Configure Clover Bootloader to always redirect (once it's booted) to boot your desired OS.You might need to experiment with different methods if the utility's site ever goes dark. I can't answer why, and Clover also doesn't have documentation that I can find either. Note: Paul's guide does NOT use Rufus (or similar) to load Clover, but a generically-named program called "Boot Disk Utility".Install Clover Bootloader to a separate drive that can be booted to, probably best with a drive attached to the SAS backplane, but an internal USB stick probably works too.Install your desired OS to the NVMe drive like you would originally want to install it (Rufus seems to be most reliable in my experience, both with Windows and Debian OSes).(I have not verified that this actually works, but conceptually it should be just fine) Nice.Īrni J's answer is exactly what I ended up doing since my R630 came with two spare HDDs, but I also found an alternative option that may work too for anyone searching for other ways. I ran into this exact issue, also with an R630, also booting from an M.2 drive, also installing Ubuntu. I found a post on Reddit where a user had the same problem but he offered no solution except some vague suggestion that one could try to boot from a USB stick first and then hand over boot to the NvMe drive - but how that would work exactly I am not sure. How come UEFI can see the installed OS / drive just fine (it seems) but fails to boot from it? Is there something I can toggle somewhere to make this work? Hence, I am trying to boot from the NVMe SSD via Clover. My NVMe SSD is visible in Windows, but I cannot boot from it, because my Legacy Bios does not recognize it. Also, the boot icon for the new OS should appear first in the list of downloads, and if I don’t confuse anything, it will be called Boot Microsoft EFI Boot from EFI. If I try to tell the system to boot from this drive regardless, it will say something like "Booting from ubuntu - boot failed" I have one SATAIII SSD with Windows installed that boots fine if I do not plug in the Clover USB key. After installing the new system on your new NVMe SSD, a record will appear in Clover that a new OS was installed from under it. If I go to system settings -> Boot settings I can see the system recongizes the drive/os but it is listed as "Unavailable: ubuntu" It installed successfully and after a reboot I get a new option in my UEFI boot menu "ubuntu" - but it is greyed out! I have plugged in a PNY XLR8 500GB M.2 NvMe drive in a Delock PCIe card and stuck it in Riser 3 on my Poweredge r630 - Although the drive doesn't show up anywhere in BIOS, I could boot the Ubuntu installer from a USB thumb drive and the installation saw the drive just fine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |